FRONT LOWER SUSPENSION ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedure listed below is for the LH side.

  • Use the same procedure for the RH side and LH side.

PROCEDURE


  1. INSTALL FRONT LOWER SUSPENSION ARM BOLT


    1. Using SST, install the new front lower suspension arm bolt.

      SST
      09726-18010
      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

  2. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH


    1. Temporarily tighten the front lower suspension arm assembly LH with the bolt and new nut.

      Note

      Insert the bolt from the front of the vehicle.

  3. INSTALL STEERING KNUCKLE LH


    1. Install the front lower arm suspension arm assembly LH with the nut to the steering knuckle LH.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

    2. Install new clip.

  4. INSTALL TIE ROD END SUB-ASSEMBLY LH

    Click here

  5. INSTALL LOWER ARM SUPPORT PLATE


    1. Install the lower arm support plate with the new bolt and new nut.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

  6. INSTALL FRONT WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  7. STABILIZE SUSPENSION

    Click here

  8. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH


    1. Fully tighten the nut on the rear of the front lower suspension arm assembly LH.

      Torque:
      85 N*m  { 867 kgf*cm, 63 ft.*lbf }

  9. INSTALL REAR ENGINE UNDER COVER LH


    1. Install the rear engine under cover LH with the 3 clips.

  10. INSPECT STEERING WHEEL CENTER POINT

  11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  12. VSC SENSOR NEUTRAL MEMORIZATION

    Click here

  13. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

    Click here

  14. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)

    Click here