REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. Install the rear axle hub and bearing assembly to the rear axle assembly with the 4 bolts.

      Torque:
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }

  2. INSTALL REAR DISC

    Click here

  3. INSTALL REAR CALIPER ASSEMBLY

    Click here

  4. STAKE REAR AXLE SHAFT NUT LH


    1. Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.

      Note


      • Be sure to perform this step even when using a new rear drive shaft assembly.

      • Keep the threaded parts free of oil and foreign matter.

    2. Install the new rear axle shaft nut.

      Torque:
      190 N*m  { 1938 kgf*cm, 140 ft.*lbf }

      Tech Tips

      Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.

  5. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  6. INSPECT REAR AXLE HUB RUNOUT

    Click here

  7. STAKE REAR AXLE SHAFT NUT LH


    1. A004HSM

      Using a chisel and hammer, stake the rear axle shaft nut LH.

  8. INSTALL REAR SPEED SENSOR LH


    1. Install the bolt and the rear speed sensor LH.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  9. INSTALL REAR WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  10. ADJUST PARKING BRAKE LEVER TRAVEL

    Click here

  11. INSPECT SPEED SENSOR SIGNAL

    Click here