REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. SEPARATE REAR SPEED SENSOR LH


    1. A004JFV

      Remove the bolt and separate the rear speed sensor LH.

      Note

      Prevent foreign matter from attaching to the sensor tip.

  3. REMOVE REAR AXLE SHAFT NUT LH

    A004J8E

    1. Using SST and a hammer, release the staked part of the rear axle shaft nut.

      SST
      09930-00010

      Note


      • Do not grind the SST.

      • Release the staked part of the nut completely; otherwise the threads of the drive shaft may get damaged.

    2. Remove the rear axle shaft nut.

  4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  5. REMOVE REAR DISC

    for floating type caliper: Click here

    for opposed type caliper: Click here

  6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. Using a plastic-faced hammer, disconnect the rear drive shaft assembly from the rear axle hub and bearing assembly LH.

      Note


      • Be careful not to damage the boot.

      • Use a wire or equivalent to prevent the rear drive shaft assembly from hanging down.

    2. A004INB

      Remove the 4 bolts and the rear axle hub and bearing assembly LH from the rear axle assembly.