REAR AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE REAR DISC

    for floating type caliper: Click here

    for opposed type caliper: Click here

  4. REMOVE REAR AXLE HUB BOLT LH


    1. Using SST, remove the rear axle hub bolt LH from rear axle hub and bearing assembly LH.

      SST
      09960-20010   ( 09961-02010, 09961-02060 )
      A004HZWE03
      Text in illustration
      *1 Nut *2 Body
      *3 Claw *4 SST (Spacer B)
      *a Place a Wrench Here - -
      A004I9S Molybdenum Grease A004KUZ Turn

      CAUTION:

      Before working, apply molybdenum grease to the bolt threads and bolt tip of SST.

      Note


      • Install SST so that claw and body are parallel

      • Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

      • Do not damage the parking brake plate sub-assembly.

      • Do not damage the rear axle carrier.

      • Do not damage the rear axle hub and bearing.

  5. INSTALL REAR AXLE HUB BOLT LH


    1. A004IB1E02
      Text in Illustration
      *1 Nut
      *2 Washer
      *a Turn
      *b Hold

      Set a new axle hub bolt onto the rear axle hub and bearing, and tighten the nut (M12 x P1.25mm (0.0492 in.)) through the washer plate to install the axle hub bolt.

      Note

      Install the nuts to prevent damage to the rear axle hub bolts.

  6. INSTALL REAR DISC

    for floating type caliper: Click here

    for oppsoed type caliper: Click here

  7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. INSTALL REAR WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }