PROPELLER SHAFT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


    1. Completely remove any oil or the like and clean the contact surfaces of the propeller shaft assembly and the rear drive pinion companion flange.

    2. Remove SST from the extension housing. (for Manual Transmission)

      SST
      09325-20010

    3. Remove SST from the extension housing. (for Automatic Transmission)

      SST
      09325-40010

    4. Insert the front propeller shaft assembly into the extension housing.

      Note

      Be careful not to damage the oil seal.

    5. Install the 2 center support bearing washers and the center support bearing.

    6. A004KA8

      Install the 2 bolts and the center support bearing bracket.

      Torque:
      52 N*m  { 530 kgf*cm, 38 ft.*lbf }
    7. A004JX8E02
      Text in Illustration
      *a Matchmark

      Align the matchmarks on the differential companion flange and the flexible coupling and connect the propeller shaft.

    8. Install the rear propeller shaft assembly with the 4 new bolts, 4 washers and 4 new nuts.

      Note

      Hold the nut and tighten the bolt.

      Torque:
      74 N*m  { 755 kgf*cm, 55 ft.*lbf }

  2. INSTALL CENTER EXHAUST PIPE ASSEMBLY

    Click here