CLUTCH PEDAL SWITCH(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL CLUTCH SWITCH ASSEMBLY


    1. Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect the clutch switch connector.

    3. A004I1TE01
      Text in Illustration
      *a No Clearance

      Without depressing the clutch pedal, check that there is no clearance between the switch shaft and the clutch pedal stopper.

      Tech Tips

      Do not turn the clutch switch assembly.

  2. INSTALL CLUTCH START SWITCH ASSEMBLY


    1. Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect the clutch start switch connector.

    3. A004I8XE01
      Text in Illustration
      *a Clearance

      With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.

      Standard clearance
      3.2 to 4.6 mm (0.1260to 0.1811in.)

      Tech Tips

      Do not turn the clutch start switch assembly.

  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

  5. INSPECT CLUTCH START SYSTEM

    Click here