INPUT SHAFT INSPECTION

PROCEDURE


  1. INSPECT NO. 2 SYNCHRONIZER RING


    1. A004KOW

      Apply manual transmission gear oil to the taper corn of the 3rd gear, and hold the No. 2 synchronizer ring in position with your hand to measure the clearance between the No. 2 synchronizer ring and 3rd gear by using a feeler gauge.

      Standard clearance
      0.8 to 1.6 mm (0.0315 to 0.0630 in.)
      Minimum clearance
      0.8 mm (0.0315 in.)

      Note

      Check the entire circumference of the gear.

      Tech Tips

      If the clearance is less than the minimum, replace the No. 2 synchronizer ring with a new one.

    2. A004HKR

      Apply manual transmission gear oil to the taper cone of the 3rd gear, and then hold the No. 2 synchronizer ring in position with your hand to check that it does not slide in the circumferential direction.

      Tech Tips

      If the No. 2 synchronizer ring slides, replace the No. 2 synchronizer ring with a new one.