Tech Tips
If a normal code is displayed during the diagnostic trouble code check although the trouble still occurs, check the electrical circuits for each symptom in the order given in the charts on the following pages and proceed to the page given for troubleshooting.
The Matrix Chart is divided into 2 chapters.
Chapter 1:
Refer to the table below when the trouble cause is considered to be electrical.
If the instruction "Proceed to next circuit inspection shown on matrix chart" is given in the flow chart of each circuit, proceed to the circuit with the next highest number in the table to continue the check.
If the trouble still occurs even though there are no abnormalities in any of the other circuits, check and replace the TCM.
| Symptom | Suspected Area | See page |
|---|---|---|
| No up-shift (1st -> 2nd) | 1. Shift solenoid valve S1 circuit *1 | |
| 2. TCM | ||
| No up-shift (2nd -> 3rd) | 1. Shift solenoid valve S2 circuit *1 | |
| 2. TCM | ||
| No up-shift (3rd -> 4th) | 1. Shift solenoid valve S3 circuit *1 | |
| 2. Engine coolant temperature sensor circuit *1 | ||
| 3. TCM | ||
| No up-shift (4th -> 5th) | 1. Shift solenoid valve S4 circuit *1 | |
| 2. Shift solenoid valve SR circuit *1 | ||
| 3. Shift solenoid valve SL) circuit *1 | ||
| 4. Shift solenoid valve SL2 circuit *1 | ||
| 2. Engine coolant temperature sensor circuit *1 | ||
| 5. TCM | ||
| No up-shift (5th -> 6th) | 1. Park/neutral position switch circuit *1 | |
| 2. Engine coolant temperature sensor circuit *1 | ||
| 3. Shift solenoid valve S2 circuit *1 | ||
| 4. TCM | ||
| No down-shift (6th -> 5th) | 1. Park/neutral position switch circuit *1 | |
| 2. Shift solenoid valve S2 circuit *1 | ||
| 3. TCM | ||
| No down-shift (5th -> 4th) | 1. Shift solenoid valve S4 circuit *1 | |
| 2. Shift solenoid valve SR circuit *1 | ||
| 3. Shift solenoid valve SL1 circuit *1 | ||
| 4. Shift solenoid valve SL2 circuit *1 | ||
| 5. TCM | ||
| No down-shift (4th -> 3rd) | 1. Shift solenoid valve S3 circuit *1 | |
| 2. TCM | ||
| No down-shift (3rd -> 2nd) | 1. Shift solenoid valve S2 circuit *1 | |
| 2. TCM | ||
| No down-shift (2nd -> 1st) | 1. Shift solenoid valve S1 circuit *1 | |
| 2. TCM | ||
| No lock-up or No lock-up off | 1. Shift solenoid valve SLU circuit *1 | |
| 2. Engine coolant temperature sensor circuit *1 | ||
| 3. Stop light switch circuit *1 | ||
| 4. Input speed sensor NT circuit *1 | ||
| 5. TCM | ||
| Shift point too high or too low | 1. Shift solenoid valve SLT circuit *1 | |
| 2. Input speed sensor NT circuit *1 | ||
| 3. Output speed sensor SP2 circuit *1 | ||
| 4. Throttle position sensor circuit *1 | ||
| 5. Pattern select SPORT switch circuit | ||
| 6. ATF temperature sensor circuit *1 | ||
| 7. TCM | ||
| 8. Park/Neutral position switch | ||
| Up-shift to 6th while engine is cold | 1. Engine coolant temperature sensor circuit *1 | |
| 2. TCM | ||
| No gear change by shifting into "+" or "-" while the shifting lever | 1. Transmission control switch circuit | |
| 2. Shift paddle switch circuit | ||
| 3. TCM | ||
| Harsh engagement (N -> D) | 1. Shift solenoid valve SLT circuit *1 | |
| 3. TCM | ||
| Harsh engagement (Lock-up) | 1. Input speed sensor NT circuit *1 | |
| 2. Output speed sensor SP2 circuit *1 | ||
| 3. Shift solenoid valve SLU circuit *1 | ||
| 4. TCM | ||
| Harsh engagement (Any driving position) | 1. Throttle position sensor circuit *1 | |
| 2. Shift solenoid valve SL1 circuit *1 | ||
| 3. Shift solenoid valve SL2 circuit *1 | ||
| 4. Shift solenoid valve SLU circuit *1 | ||
| 5. Shift solenoid valve SLT circuit *1 | ||
| 6. Input speed sensor NT circuit *1 | ||
| 7. TCM | ||
| Poor acceleration | 1. Shift solenoid valve SLT circuit *1 | |
| 2. Pattern select (SNOW) switch circuit | ||
| 3. TCM | ||
| ECT SNOW does not operate | 1. Shift solenoid valve SLT circuit *1 | |
| 2. Pattern select (SNOW) switch circuit | ||
| 3. TCM | ||
| ECT SPORT does not operate | 1. Shift solenoid valve SLT circuit *1 | |
| 2. Pattern select (SPORT) switch circuit | ||
| 3. TCM | ||
| Harsh engagement (1st -> 2nd -> 3rd -> 4th -> 5th) | Shift solenoid valve SR circuit *1 | |
| Slip or shudder (5th -> 6th and 6th -> 5th) | Shift solenoid valve SR circuit *1 | |
| Shift solenoid valve SLT circuit *1 |
Tech Tips
*1: When the circuit is detective, a DTC may be output.
| Symptom | Suspected Area | See page |
|---|---|---|
| Vehicle does not move in any forward position and reverse positions | 1. Transmission control rod | |
| 2. Manual valve | ||
| 3. Parking lock pawl | ||
| 4. Rear planetary gear unit | ||
| 5. Torque converter clutch | ||
| Vehicle does not move in R position | 1. Valve body assembly | |
| 2. Brake No. 4 (B4) | ||
| No up-shift (1st -> 2nd) | 1. Valve body assembly | |
| 2. Brake No. 3 (B3) | ||
| 3. One-way clutch No. 1 (F1) | ||
| 4. One-way clutch No. 2 (F2) | ||
| No up-shift (2nd -> 3rd) | 1. Valve body assembly | |
| 2. Clutch No. 3 (C3) | ||
| No up-shift (3rd -> 4th) | 1. Valve body assembly | |
| 2. Clutch No. 2 (C2) | ||
| No up-shift (4th -> 5th) | 1. Valve body assembly | |
| 2. Brake No. 1 (B1) | ||
| No up-shift (5th -> 6th) | 1. Valve body assembly | |
| 2. Brake No. 2 (B2) | ||
| No down-shift (6th -> 5th) | Valve body assembly | |
| No down-shift (5th -> 4th) | Valve body assembly | |
| No down-shift (4th -> 3rd) | Valve body assembly | |
| No down-shift (3rd -> 2nd) | Valve body assembly | |
| No down-shift (2nd -> 1st) | Valve body assembly | |
| No lock-up or No lock-up off | 1. Valve body assembly | |
| 2. Torque converter clutch | ||
| Harsh engagement (N -> D) | 1. Valve body assembly | |
| 2. C1 accumulator | ||
| 3. Clutch No. 1 (C1) | ||
| 4. One-way clutch No. 3 (F3) | ||
| 5. One-way clutch No. 4 (F4) | ||
| Harsh engagement (Lock-up) | 1. Valve body assembly | |
| 2. Torque converter clutch | ||
| Harsh engagement (N -> R) | 1. Valve body assembly | |
| 2. C3 accumulator | ||
| 3. Clutch No. 3 (C3) | ||
| 4. Brake No. 4 (B4) | ||
| 5. One-way clutch No. 1 (F1) | ||
| Harsh engagement (1st -> 2nd -> 3rd -> 4th -> 5th -> 6th) | Valve body assembly | |
| Harsh engagement (1st -> 2nd) | 1. Valve body assembly | |
| 2. B3 accumulator | ||
| 3. Brake No. 3 (B3) | ||
| 4. One-way clutch No. 1 (F1) | ||
| 5. One-way clutch No. 2 (F2) | ||
| Harsh engagement (2nd -> 3rd) | 1. Valve body assembly | |
| 2. C3 accumulator | ||
| 3. Clutch No. 3 (C3) | ||
| Harsh engagement (3rd -> 4th) | 1. Valve body assembly | |
| 2. C2 accumulator | ||
| 3. Clutch No. 2 (C2) | ||
| Harsh engagement (4th -> 5th) | 1. Valve body assembly | |
| 2. B1 accumulator | ||
| 3. Brake No. 1 (B1) | ||
| Harsh engagement (5th -> 6th) | 1. Valve body assembly | |
| 2. B2 accumulator | ||
| 3. Brake No. 2 (B2) | ||
| Harsh engagement (6th -> 5th) | 1. Valve body assembly | |
| 2. C3 accumulator | ||
| 3. Clutch No. 3 (C3) | ||
| Slip or shudder (Forward and reverse: After warm-up) | 1. Valve body assembly | |
| 2. Oil strainer | ||
| 3. One-way clutch No. 1 (F1) | ||
| 4. Clutch No. 3 (C3) | ||
| 5. Torque converter clutch | ||
| Slip or shudder (Particular position: Just after engine starts) | Torque converter clutch | |
| Slip or shudder (R position) | 1. Brake No. 4 (B4) | |
| 2. One-way clutch No. 1 (F1) | ||
| 3. Clutch No. 3 (C3) | ||
| Slip or shudder (1st) | 1. Clutch No. 1 (C1) | |
| 2. One-way clutch No. 3 (F3) | ||
| 3. One-way clutch No. 4 (F4) | ||
| Slip or shudder (2nd) | 1. Clutch No. 1 (C1) | |
| 2. Brake No. 3 (B3) | ||
| 3. One-way clutch No. 1 (F1) | ||
| 4. One-way clutch No. 2 (F2) | ||
| 5. One-way clutch No. 4 (F4) | ||
| Slip or shudder (3rd) | 1. Clutch No. 1 (C1) | |
| 2. Clutch No. 3 (C3) | ||
| 3. One-way clutch No. 1 (F1) | ||
| 4. One-way clutch No. 4 (F4) | ||
| Slip or shudder (4th) | 1. Clutch No. 1 (C1) | |
| 2. Clutch No. 2 (C2) | ||
| 3. One-way clutch No. 4 (F4) | ||
| Slip or shudder (5th) | 1. Clutch No. 2 (C2) | |
| 2. Clutch No. 3 (C3) | ||
| 3. Brake No. 1 (B1) | ||
| Slip or shudder (6th) | 1. Clutch No. 2 (C2) | |
| 2. Brake No. 2 (B2) | ||
| No engine braking (1st +- 4th: S position) | Clutch No. 4 (C4) | |
| No engine braking (1st: 1 position) | 1. Valve body assembly | |
| 2. Brake No. 4 (B4) | ||
| No engine braking (2nd: 2 position) | 1. Valve body assembly | |
| 2. Brake No. 2 (B2) | ||
| No engine braking (3rd: 3 position) | 1. Valve body assembly | |
| 2. Brake No. 1 (B1) | ||
| No engine braking (4th: 4 position) | Valve body assembly | |
| No kick-down | Valve body assembly | |
| Shift point too high or too low | Valve body assembly | |
| Poor acceleration (All positions) | 1. Valve body assembly | |
| 2. Torque converter clutch | ||
| Poor acceleration (6th) | 1. Brake No. 2 (B2) | |
| 2. Clutch No. 2 (C2) | ||
| 3. Front planetary gear unit | ||
| Engine stalls when starting off or stopping | 1. Valve body assembly | |
| 2. Torque converter clutch |