IGNITION SWITCH INSPECTION

PROCEDURE


  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    1. A004JBPE03
      Text in Illustration
      *a

      Component without harness connected

      (Ignition or starter Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      All combinations of all terminals LOCK 10 kΩ or higher
      2 (AM2) - 3 (ACC) ACC Below 1 Ω

      2 (AM2) - 3 (ACC) - 4 (IG1)

      6 (IG2) - 7 (AM1)

      		 ON Below 1 Ω

      1 (ST1) - 2 (AM2) - 4 (IG1)

      6 (IG2) - 7 (AM1) - 8 (ST2)

      		 START Below 1 Ω

      If the result is not as specified, replace the ignition or starter switch assembly.