AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A004H64E02

      Using SST, install the air fuel ratio sensor onto the exhaust manifold.

      SST
      09224-00010
      Torque:
      Without SST
      21 N*m  { 214 kgf*cm, 16 ft.*lbf }
      With SST
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.087 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values Click here.

    2. Engage the 2 clamps.

    3. Connect the air fuel ratio sensor connector.

  2. CONNECT BATTERY NEGATIVE TERMINAL

    Click here

  3. INSPECT FOR EXHAUST GAS LEAK

    Click here