SFI SYSTEM FAIL-SAFE CHART

If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.

DTC Code	Fail-Safe Operation	Fail-Safe Deactivation Condition
P000A P000C P0010 P0011 P0016 P0018 P0020 P0021 P0341 P0345 P0346	Fix intake VVT control at intermediate position	After recovery in normal status, turn the ignition switch to ON again
P000B P000D P0013 P0014 P0017 P0019 P0023 P0024 P0365 P0366 P0390 P0391	Fix exhaust VVT control at maximum advanced angle	After recovery in normal status, turn the ignition switch to ON again
P0031 P0032 P0131 P0132 P0134	Stop air fuel ratio feedback control	After recovery in normal status, turn the ignition switch to ON again
P0037 P0137 P0138 P013A P013B P013E P013F P0140 P0141	Stop air fuel ratio feedback control	Return to normal status
P0087 P0088 P0191 P0192 P0193 P1235	Stop fuel pump assembly drive (high pressure side) Fix fuel pressure at 0.4 MPa (4.07 kgf/cm², 57.9 psi). Cut fuel at 1500 rpm or more	After recovery in normal status, turn the ignition switch to ON again
P0101 P0102 P0103	Make the engine load the manifold absolute pressure converted estimated value	Return to normal status
P0068 P0107 P0108	Make the manifold absolute pressure value the mass air flow meter converted estimated value	Return to normal status
P0111 P0112 P0113	Fix inlet air temperature at 20°C (68°F)	Return to normal status
P0116 P0117 P0118 P0125	Fix coolant temperature at 70°C ( 158°F) Stop intake and exhaust VVT	Return to normal status
P0172	Stop purge control	Return to normal status
P0196 P0197 P0198	Fix engine oil temperature at 70°C (158°F)	Return to normal status
P0201 P0202 P0203 P0204 P062D P1261 P1262 P1263 P1264	Cut fuel at 1500 rpm or more Cut fuel to abnormal cylinders	After recovery in normal status, turn the ignition switch to ON again
P062F P0122 P0123 P0222 P0223 P0604 P0605 P0606 P060A P060B P1160 P2101 P2102 P2109 P2119 P2135	Stop electronic throttle control, and fix the throttle valve opening angle (7 degrees)	After recovery in normal status, turn the ignition switch to ON again
P0327 P0328 P0332 P0333	Maximum retard angle	Return to normal status
P0451	Stop leak detection pump control	Return to normal status
P0500	Fix ECU recognized vehicle speed at 10 km/h (6.2 mph)	Return to normal status
P0851 P0852	Turn off the gear position display within the combination meter (for Manual Transmission)	Return to normal status
P1451 P2404	Fix atmospheric pressure at 101.3 kPa (760 mmHg)	Return to normal status
P2122 P2123 P2127 P2128	Accelerator pedal sensor assembly has 2 sensor circuits: Main and Sub If either circuit malfunctions, substitute the normal accelerator position sensor until the prescribed angle. If both circuits malfunction, fix accelerator position at prescribed angle (15%).	After recovery in normal status, turn the ignition switch to ON again
P2138	Fix accelerator pedal angle Stop electronic throttle control, and fix the throttle valve opening angle	After recovery in normal status, turn the ignition switch to ON again