SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL SHIFT LEVER ASSEMBLY


    1. A004I8IE03

      Install and tighten the 4 bolts in the sequence shown in the illustration.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    2. Engage the wire harness clamp.

    3. Connect the 2 connectors.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. While pushing the shift lock release button, move the shift lever to N.

    2. A004IPJ

      Using tape, hold a 0.3 mm feeler gauge on the floor shift control select lever.

    3. A004HTE

      Using tape, attach the floor shift control select lever to the console box assembly.

      Note

      Make sure that the feeler gauge is not on the area shown in the illustration.

    4. A004IJME01

      Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

    5. Temporarily install the floor shift gear shifting rod sub-assembly with the nut.

    6. Tighten the nut while lightly pushing the lever rearward.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note

      Do not push the lever too hard.

  4. INSPECT SHIFT LEVER POSITION

    Click here

  5. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  6. INSTALL NO. 1 ENGINE UNDER COVER

    Click here