HEIGHT CONTROL SENSOR INSPECTION


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A01FS2WE01
      Text in Illustration
      *a

      Component without harness connected

      (Rear Height Control Sensor Sub-assembly LH)
      *b Low (-)
      *c Normal
      *d High (+)
      *e Stopper position at lowest vehicle height
      *f Stopper position at highest vehicle height

      Check the rear height control sensor sub-assembly LH:


      1. Connect 3 dry batteries of 1.5 V in series.

      2. Connect the positive (+) end of the batteries to terminal 3 of the height control sensor and the negative (-) end of the batteries to terminal 1. While slowly moving the sensor link up and down, measure the voltage between terminal 2 and terminal 1.

      3. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Condition Specified Condition
        1 - 2 High (+) Approx. 4.5 V
        Normal Approx. 2.5 V
        Low (-) Approx. 0.5 V

        Note


        • Do not apply a voltage of more than 6 V.

        • Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.