AUTOMATIC LIGHT CONTROL SENSOR ON-VEHICLE INSPECTION


  1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR


    1. A01FT0HE07

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      O1-6 (CLTB) - O1-3 (CLTE) Power switch on (IG) 11 to 14 V

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      O1-3 (CLTE) - Body ground Always Below 1 Ω

    3. Reconnect the O1 sensor connector.

    4. A01FV4QE01
      Text in Illustration
      *a

      Component with harness connected

      (Automatic Light Control Sensor)

      Check the waveform of the O1 sensor connector.

      Waveform
      Tester Connection Tool Setting Switch Condition Specified Condition
      O1-3 (CLTE) - O1-5 (CLTS) 5 V/DIV., 5 msec./ DIV. Power switch on (IG), Headlight dimmer switch on AUTO Correct waveform is as shown

      Tech Tips

      If the ambient light becomes brighter, width A becomes narrower.

      If the result is not as specified, there may be a malfunction in the sensor.