AFS ECU (for RHD) INSTALLATION


  1. INSTALL HEADLIGHT SWIVEL ECU ASSEMBLY


    1. Connect the connector.

    2. Install the headlight swivel ECU assembly with the bolt and nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Attach the clip to install the connector.

  2. INSTALL ACCELERATION SENSOR ASSEMBLY


    1. A01FRBHE08
      Text in Illustration
      *a 40°

      Check that the control rod of the front shock absorber is in the position shown in the illustration.

      Note

      If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position before installing the absorber control actuator.

    2. A01FU6HE01
      Text in Illustration
      *a 40°

      Install the absorber control actuator to the actuator support bracket.

    3. Turn the actuator clockwise 40° until a click is felt.

      Note


      • Before turning the actuator, make sure to check that the actuator output shaft and control rod are securely connected.

      • Do not turn the actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.

  3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    A01FVEAE01
    Text in Illustration
    *1 Screw <A>
    *2 Bolt <E>

    1. Connect the connectors and attach the clamp.

    2. Attach the 6 clips to install the glove compartment door assembly.

    3. Install the 3 screws <A> and 2 bolts <E>.

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connectors and attach the clamp.

    2. Attach the 5 clips and 2 guides to install the No. 2 instrument panel under cover sub-assembly.

  5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


    1. Attach the 5 clips and 2 guides to install the instrument panel finish panel end LH.

  6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. Connect the connector.

    2. Attach the 9 clips and guide to install the center instrument cluster finish panel.

  7. INSTALL INSTRUMENT SIDE PANEL LH


    1. Attach the 7 clips to install the instrument side panel LH.

  8. INSTALL FRONT DOOR OPENING TRIM COVER LH


    1. Attach the 5 claws to install the front door opening trim cover LH.

      Note

      After installing the front door opening trim cover LH, make sure that the lip of the front door opening trim weatherstrip LH is not pinched.

  9. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Attach the 10 claws and 4 clips to install the front door scuff plate LH.

  10. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH


    1. Install the luggage compartment trim cover LH.

  12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


    1. Install the luggage compartment floor mat.