AFS ECU (for LHD) INSTALLATION


  1. INSTALL HEADLIGHT SWIVEL ECU ASSEMBLY


    1. Connect the connector.

    2. Install the headlight swivel ECU assembly with the bolt and nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Attach the clip to install the connector.

  2. INSTALL ACCELERATION SENSOR ASSEMBLY


    1. A01FRBHE08
      Text in Illustration
      *a 40°

      Check that the control rod of the front shock absorber is in the position shown in the illustration.

      Note

      If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position before installing the absorber control actuator.

    2. A01FU6HE01
      Text in Illustration
      *a 40°

      Install the absorber control actuator to the actuator support bracket.

    3. Turn the actuator clockwise 40° until a click is felt.

      Note


      • Before turning the actuator, make sure to check that the actuator output shaft and control rod are securely connected.

      • Do not turn the actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.

  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here.