SIDE TURN SIGNAL LIGHT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE OUTER MIRROR LH


    1. A01FUQEE02

      Apply protective tape to the areas shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

      Text in Illustration
      *1 Tape
      *2 Moulding Remover D

    3. Using a moulding remover d, detach the 2 claws at the upper part of the outer rear view mirror as shown in the illustration.

    4. A01FSL6E01

      Push the lower part of the mirror surface and tilt it.

    5. Apply protective tape to the areas shown in the illustration.

      Text in Illustration
      *1 Tape
      *2 Moulding Remover D

    6. Using a moulding remover d, detach the 2 claws at the upper part of the outer rear view mirror as shown in the illustration.

    7. A01FUZ1

      w/ Blind Spot Monitor:


      1. Detach the 2 clamps.

      2. Disconnect the 4 connectors and remove the outer mirror LH.

    8. A01FSJ1

      w/o Blind Spot Monitor:


      1. Detach the clamps.

      2. Disconnect the 3 connectors and remove the outer mirror LH.

  2. REMOVE NO. 2 OUTER MIRROR COVER LH


    1. A01FSC7

      Remove the 5 screws.

    2. Detach the 2 claws and 4 guides and remove the visor assembly.

    3. A01FTAC

      Detach the 2 guides.

    4. A01FTHM

      Disconnect the connector and remove the No. 2 outer mirror cover LH.

  3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. A01FU7V

      Detach the pin and remove the side turn signal light assembly LH