LIGHTING SYSTEM DRL Relay Circuit

DESCRIPTION

The main body ECU controls the daytime running lights.

WIRING DIAGRAM

A01FU87E01

INSPECTION PROCEDURE

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • Recognition code registration is necessary when replacing the main body ECU (multiplex network body ECU).

  • If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (DAYTIME RUNNING LIGHT)


    1. Using the GTS, perform the Active Test Click here.

      Main Body
      Tester Display Test Part Control Range Diagnostic Note
      Daytime Running Light Daytime running light ON/OFF -
      OK
      Daytime running lights come on.

    NG

    CHECK HARNESS AND CONNECTOR (NO. 2 INTEGRATION RELAY - BATTERY AND BODY GROUND) Click here

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

  2. CHECK HARNESS AND CONNECTOR (NO. 2 INTEGRATION RELAY - BATTERY AND BODY GROUND)


    1. A01FQ6CE06
      Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 2 Integration Relay)

      Disconnect the No. 2 integration relay connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      1G-1 (ALT) - Body ground Always 11 to 14 V
      1B-7 (BATT) - Body ground
      1B-8 (IG1A) - Body ground Power switch on (IG)

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1B-10 (GNDB) - Body ground Always Below 1 Ω
      1A-22 (GNDA) - Body ground

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (NO. 2 INTEGRATION RELAY - COWL SIDE JUNCTION BLOCK LH)


    1. Disconnect the 1A No. 2 integration relay connector.

    2. Disconnect the 5D cowl side junction block LH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1A-12 (DRL) - 5D-23 Always Below 1 Ω
      1A-12 (DRL) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. INSPECT COWL SIDE JUNCTION BLOCK LH


    1. A01FU4ME01

      Remove the cowl side junction block LH Click here.

    2. Remove the main body ECU from the cowl side junction block LH Click here.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-25 (DRL) - 5D-23 Always Below 1 Ω

    NG

    REPLACE COWL SIDE JUNCTION BLOCK LH Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here