LIGHTING SYSTEM Hazard Warning Switch Circuit

DESCRIPTION

The combination meter receives hazard warning signal switch information signals and illuminates the hazard warning light(s).

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING GTS (HAZARD WARNING SIGNAL SWITCH)

   
   

   1. Using the GTS, read the Data List Click here.

      Combination Meter

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Hazard Flasher Switch	Hazard warning signal switch signal / ON or OFF	ON: Hazard warning signal switch on OFF: Hazard warning signal switch off	-

      OK
      Normal conditions listed above are displayed.

   
   

   NG

   INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD WARNING SIGNAL SWITCH) Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

2. INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD WARNING SIGNAL SWITCH)

   
   

   1. Remove the multi-media module receiver (hazard warning signal switch) Click here.

   2. Inspect the multi-media module receiver (hazard warning signal switch) Click here.

   
   

   NG

   REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD WARNING SIGNAL SWITCH) Click here

   OK

3. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER [HAZARD WARNING SIGNAL SWITCH] - COMBINATION METER)

   
   

   1. Disconnect the N69 multi-media module receiver (hazard warning signal switch) connector.

   2. Disconnect the N39 combination meter connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition N69-10 (LJB) - N39-5 (HAZM) Always Below 1 Ω N69-9 (HAZ) - N39-11 (HZSW) Always Below 1 Ω N69-10 (LJB) - Body ground Always 10 kΩ or higher N69-9 (HAZ) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

   REPLACE COMBINATION METER ASSEMBLY Click here