LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM TERMINALS OF ECU


  1. CHECK COWL SIDE JUNCTION BLOCK LH AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

  2. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

    A01FTANE33

    1. Disconnect the N94 and N95 certification ECU (smart key ECU assembly) connectors.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      N94-1 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
      N95-4 (CUTB) - Body ground P - Body ground Dark current cut fuse pin input signal* Always 11 to 14 V
      N95-5 (+B) - Body ground GR - Body ground Battery power supply Always 11 to 14 V
      N95-16 (IG) - Body ground B - Body ground Ignition power supply Power switch off Below 1 V
      Power switch on (IG) 11 to 14 V

      • *: In order to prevent the vehicle auxiliary battery from being depleted when the vehicle is shipped long distances, a fuse that cuts unnecessary electrical load while the vehicle is being shipped is set in the circuit. If the fuse is removed, the circuit becomes open. If the fuse that is between the vehicle auxiliary battery and terminal CUTB is removed and the circuit is open, the certification ECU (smart key ECU assembly) changes to a certain control mode (example: the transmission of electric waves every 0.25 seconds. that form the detection area stops).

    3. Reconnect the N94 and N95 certification ECU (smart key ECU assembly) connectors.

    4. Measure the voltage according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      N98-22 (TSW5) - N94-1 (E) SB - W-B Luggage electrical key switch input signal Power switch on (IG), luggage compartment door is fully closed and luggage electrical key switch off Pulse generation

  3. CHECK LUGGAGE CLOSER MOTOR ASSEMBLY Click here