POWER WINDOW REGULATOR MOTOR (for Rear Door) INSPECTION


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    Note

    Do not apply positive (+) auxiliary battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor.


    1. Apply positive (+) auxiliary battery voltage to the connector terminal 2 (B).

    2. Apply negative (-) auxiliary battery voltage to the connector terminals 1 (E) and 7 (DWN1) / 10 (UP1).

    3. A01FR8XE02
      Text in Illustration
      *1 Motor Gear
      *a

      Component without harness connected

      (Power Window Regulator Motor Assembly LH)
      A01FTNO clockwise
      A01FRJI counterclockwise

      Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 10 (UP1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 10 (UP1)

      		 Motor gear rotates counterclockwise (UP)

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 7 (DWM1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 7 (DWN1)

      		 Motor gear rotates clockwise (DOWN)

      If the result is not as specified, replace the power window regulator motor assembly LH.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

    Note

    Do not apply positive (+) auxiliary battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor.


    1. Apply positive (+) auxiliary battery voltage to the connector terminal 2 (B).

    2. Apply negative (-) auxiliary battery voltage to the connector terminals 1 (E) and 7 (DWN1) / 10 (UP1).

    3. A01FQUXE02
      Text in Illustration
      *1 Motor Gear
      *a

      Component without harness connected

      (Power Window Regulator Motor Assembly RH)
      A01FTNO clockwise
      A01FRJI counterclockwise

      Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 10 (UP1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 10 (UP1)

      		 Motor gear rotates counterclockwise (UP)

      Battery positive (+) → 2 (B)

      Battery negative (-): 1 (E) (3 seconds or more) → 1 (E) and 7 (DWM1) (within 1 second) → 1 (E) (within 1 second) → 1 (E) and 7 (DWN1)

      		 Motor gear rotates clockwise (DOWN)

      If the result is not as specified, replace the power window regulator motor assembly RH.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.