REAR POWER WINDOW SWITCH INSPECTION


  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

    A01FURQE01
    Text in Illustration
    *a

    Component without harness connected

    (Power Window Regulator Switch Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      2 (UP) - 5 (GND) Manual UP operation Below 1 Ω
      10 (DOWN) - 5 (GND) Manual DOWN operation Below 1 Ω

      2 (UP) - 5 (GND)

      4 (AUTO) - 5 (GND)

      		 AUTO UP operation Below 1 Ω

      10 (DOWN) - 5 (GND)

      4 (AUTO) - 5 (GND)

      		 AUTO DOWN operation Below 1 Ω

      If the result is not as specified, replace the power window regulator switch assembly.

    2. A01FURQE02
      Text in Illustration
      *a

      Component without harness connected

      (Power Window Regulator Switch Assembly)

      Apply auxiliary battery voltage to the power window regulator switch and check that the LED illuminates.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 8 (LED)

      Battery negative (-) → 5 (GND)

      		 LED illuminates

      If the result is not as specified, replace the power window regulator switch assembly.