All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter

DESCRIPTION

When a key switch is pushed: 1) the door control receiver receives the key signal; 2) the door control receiver sends a signal to the certification ECU; 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motors; and 4) the power window regulator motor assemblies are activated.
When the driver door key cylinder (key-linked switch) is turned: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motors; and 3) the power window regulator motor assemblies are activated.

INSPECTION PROCEDURE

Note

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

Tech Tips

Since the power window control system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.

PROCEDURE

CHECK BASIC FUNCTION (WIRELESS AND POWER DOOR LOCK CONTROL SYSTEM)

Check that the wireless transmitter Click here and driver door key cylinder (key-linked switch) Click here lock and unlock all the doors normally.

Result
Result	Proceed to
Transmitter and driver door key cylinder operate normally	A
Transmitter does not operate normally	B
Driver door key cylinder does not operate normally	C

B

GO TO WIRELESS DOOR LOCK CONTROL SYSTEM Click here

C

GO TO POWER DOOR LOCK CONTROL SYSTEM Click here

A

CHECK MANUAL UP/DOWN FUNCTION
1. Check that the manual up/down function using the multiplex network master switch and power window regulator switches can operate all the power windows Click here.
  
  OK
  
  Manual up/down function is normal.
NG
GO TO PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

OK
CHECK REMOTE UP/DOWN FUNCTION
1. Check that the remote up/down function using the multiplex network master switch operates the power windows Click here.
  
  OK
  
  Remote up/down function is normal.
NG
GO TO PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

POWER WINDOW CONTROL SYSTEM All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter