ROOF HEADLINING REASSEMBLY

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL SPOT LIGHT ASSEMBLY LH


    1. Connect the connector.

    2. Attach the 2 claws to install the spot light assembly LH.

    3. Install the screw.

  2. INSTALL SPOT LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL NO. 1 ROOF WIRE


    1. w/ Sliding Roof:


      1. Apply butyl tape as shown in the illustration.

        Tech Tips

        Place the tape securely so that it is not misaligned or peeling.

        A01FUCGE01
        Text in Illustration
        *1 Butyl Tape - -

      2. Align the positioning tape of the No. 1 roof wire with the protrusion of the roof headlining and wrap tape around them as shown in the part of the illustration labeled A.

      3. Attach the No. 1 roof wire to the butyl tape.

        Tech Tips


        • Adjust the slack of the No. 1 roof wire in the parts of the illustration labeled B and apply tape.

        • Make sure that the No. 1 roof wire is securely attached to the roof headlining along its entire length and that it is not twisted.

      4. Attach the clamps.

      5. Apply tape to the marked areas to fix the No. 1 roof wire in place.

      6. Turn the visor connectors approximately 90° clockwise to install them to the roof headlining.

        A01FTGOE01
        Text in Illustration
        *1 Visor Connector *2 No. 1 Roof Wire Positioning Tape
        *3 Tape *4 Roof Headlining

    2. w/o Sliding Roof:


      1. Apply butyl tape as shown in the illustration.

        Tech Tips

        Place the tape securely so that it is not misaligned or peeling.

        A01FUWTE01
        Text in Illustration
        *1 Butyl Tape - -

      2. Align the positioning tape of the No. 1 roof wire with the protrusion of the roof headlining and wrap tape around them as shown in the part of the illustration labeled A.

      3. Attach the No. 1 roof wire to the butyl tape.

        Tech Tips


        • Adjust the slack of the No. 1 roof wire in the parts of the illustration labeled B and apply tape.

        • Make sure that the No. 1 roof wire is securely attached to the roof headlining along its entire length and that it is not twisted.

      4. Attach the clamps.

      5. Apply tape to the marked areas to fix the No. 1 roof wire in place.

      6. Turn the visor connectors approximately 90° clockwise to install them to the roof headlining.

        A01FUSEE01
        Text in Illustration
        *1 Visor Connector *2 No. 1 Roof Wire Positioning Tape
        *3 Tape *4 Roof Headlining

  4. INSTALL VANITY LIGHT ASSEMBLY

    Tech Tips

    Use the same procedure for both vanity lights.


    1. Attach the 3 claws to install the vanity light.