FRONT BLOWER MOTOR REMOVAL


  1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FSJSE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  2. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE INSTRUMENT SIDE PANEL RH

    A01FQQME01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel RH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel RH.

    3. w/ Airbag Cut Off Switch:


      1. Disconnect the connector.

  4. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    A01FS1UE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel finish panel end RH.

    2. Detach the 5 clips and 2 guides and remove the instrument panel finish panel end RH.

  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01FT2W

    1. Detach the 5 clips and 2 guides.

    2. Disconnect the connectors, detach the clamp and remove the No. 2 instrument panel under cover sub-assembly.

  7. REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY


    1. A01FRRK

      Disconnect the connector.

    2. Remove the 3 screws and blower with fan motor sub-assembly.

    3. When reusing the blower motor with fan sub-assembly:


      1. Remove the heater packing from the blower motor with fan sub-assembly.