REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH

1. Install the rear seat airbag assembly LH to the rear seatback plate LH with 2 new nuts.

   Torque:

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

2. Attach the harness clamp to the rear seatback plate LH.

3. Install the rear seatback plate LH to the rear seatback assembly together with the rear seat airbag assembly LH with 2 new nuts.

   Torque:

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

4. Attach the airbag connector to the frame of the bench type rear seatback pad.

5. Connect the bracket of the bench type rear seatback cover with a new nut.

   Torque:

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   Note

   After the bench type rear seatback cover is installed, make sure the bench type rear seatback cover bracket is not twisted.

6. 

   Text in Illustration

   *1	Hog Ring Pliers
   *2	Hog Ring

   Using hog ring pliers, install the bench type rear seatback cover to the bench type rear seatback pad with new hog rings.

   Note

   
   

   • Be careful not to damage the cover.

   • When installing the hog rings, avoid wrinkling the cover.

INSTALL REAR SEAT ASSEMBLY

Click here

CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

INSPECT SRS WARNING LIGHT

Click here