FRONT SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

    CAUTION:


    • The nuts must not be reused.

    • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.


    1. Install the front seatback airbag assembly with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Attach the connector clamp to connect it to the front seatback frame sub-assembly.

    3. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. A01FS4RE01
        Text in Illustration
        *1 Outer Housing

        While holding the outer housing, be sure to engage the connector until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).

  2. INSTALL FRONT SEATBACK SUPPORT LH (for Sports Seat Type, Driver Side)


    1. Install the front seatback support LH with the nut.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    2. Install both paddles of the front seatback support LH with the 4 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Connect the connector.

  3. INSTALL FRONT SEATBACK SUPPORT LH (for Luxury Seat Type)


    1. Install the front seatback support LH with the nut.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    2. Install both paddles of the front seatback support LH with the 4 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Connect the connector.

  4. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

    for Sports Seat Type: Click here

    for Luxury Seat Type: Click here

    for Standard Seat Type: Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. INSPECT SRS WARNING LIGHT

    Click here