REAR AIRBAG SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR AIRBAG SENSOR LH


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the rear airbag sensor.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the outer housing, be sure to engage the connector until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).

        A01FQB7E08
        Text in Illustration
        *1 Outer Housing - -

    5. Check that there is no looseness in the installation parts of the rear airbag sensor.

  2. INSTALL REAR SEAT SIDE GARNISH LH


    1. Attach the 4 claws and guide to install the rear seat side garnish LH.

      Note

      After installing the rear seat side garnish LH, make sure that the lip of the rear door opening trim weatherstrip LH is not pinched.

  3. INSTALL REAR DOOR SCUFF PLATE LH


    1. Attach the 10 claws and 3 clips to install the rear door scuff plate LH.

  4. INSTALL REAR SEAT ASSEMBLY

    Click here

  5. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here

  8. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH


    1. Install the luggage compartment trim cover.

  9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


    1. Install the luggage compartment floor mat.