AIRBAG SYSTEM, Diagnostic DTC:B1615/14

DTC Code DTC Name
B1615/14 Front Airbag Sensor LH Malfunction

DESCRIPTION

The front airbag sensor LH consists of a diagnostic circuit and frontal deceleration sensor, etc.

If the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH circuit.

DTC Code DTC Detection Condition Trouble Area
B1615/14

Either condition is met:


  • A front airbag sensor LH malfunction.

  • A center airbag sensor assembly malfunction.

  • Front airbag sensor LH

  • Center airbag sensor assembly

WIRING DIAGRAM

A01FQEGE09

INSPECTION PROCEDURE

Note


  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  • When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.

PROCEDURE


  1. CHECK FRONT AIRBAG SENSOR LH

    A01FRCDE20
    Text in Illustration
    *1 Front Airbag Sensor RH
    *2 Center Airbag Sensor Assembly

    1. Turn the power switch off.

    2. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.

    3. Interchange the front airbag sensor LH with RH and connect the connectors to them.

    4. Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.

    5. Turn the power switch on (IG), and wait for at least 60 seconds.

    6. Clear the DTCs stored in memory Click here.

    7. Turn the power switch off.

    8. Turn the power switch on (IG), and wait for at least 60 seconds.

    9. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC B1615/14 is output A
      DTC B1610/13 is output B
      DTC B1610/13 and B1615/14 are not output C

      Tech Tips

      Codes other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

    10. Turn the power switch off.

    11. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.

    12. Return the front airbag sensor RH and LH to their original positions and connect the connectors to them.


    A

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here

    B

    REPLACE FRONT AIRBAG SENSOR LH Click here

    C

    USE SIMULATION METHOD TO CHECK Click here