TRIP SWITCH INSPECTION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSPECT TRIP SWITCH

    A01FRQFE03
    Text in Illustration
    *1 ODO TRIP Switch
    *a

    Component without harness connected

    (Trip Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (A/B) - 5 (E)

      ODO TRIP switch on

      (Pushed)

      		 Below 1 Ω
      2 (A/B) - 5 (E)

      ODO TRIP switch off

      (Not pushed)

      		 10 kΩ or higher

      If the result is not as specified, replace the trip switch.

    2. A01FRQFE02
      Text in Illustration
      *a

      Component without harness connected

      (Trip Switch)

      Apply battery voltage to the connector and check the illumination condition.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 8 (ILL+)

      Battery negative (-) → Terminal 6 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the trip switch.