DOOR COURTESY LIGHT (for Rear Door) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A01FVID

      Detach the 2 clips and 5 claws.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01FT6P

      Detach the 3 claws and remove the rear door inside handle bezel plug.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01FTBQ

      Remove the 3 screws.

    2. Detach the 8 clips.

    3. A01FVC3E01

      Detach the reference boss in the direction indicated by the arrow in the illustration.

    4. Using a screwdriver, detach the 3 claws and remove the rear door trim board.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Reference Boss
      *2 Protective Tape

    5. Disconnect each connector.

    6. A01FROJ

      Disconnect the rear door lock remote control cable and rear door inside locking cable.

  4. REMOVE NO. 2 COURTESY LIGHT ASSEMBLY


    1. A01FR6D

      Detach the claw and remove the No. 2 courtesy light assembly.

    2. Disconnect the connector.

  5. REMOVE NO. 2 COURTESY LIGHT BULB


    1. A01FS13

      Detach the 2 claws and remove the cover.

    2. Remove the No. 2 courtesy light bulb from the No. 2 courtesy light assembly.