LIGHTING SYSTEM IG Signal Circuit

DESCRIPTION

This circuit detects whether the power switch is on (IG) or off, and sends this information to the main body ECU.

WIRING DIAGRAM

A01FVMGE02

INSPECTION PROCEDURE

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • Recognition code registration is necessary when replacing the main body ECU (multiplex network body ECU).

  • If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

PROCEDURE


  1. READ VALUE USING GTS (IG SW)


    1. Using the GTS, read the Data List Click here.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG SW Power switch on (IG) signal / ON or OFF

      ON: Power switch on (IG)

      OFF: Power switch off

      		 "OFF" is also displayed for this item when the power switch is on (ACC).
      OK
      The display is as specified in the normal condition column.

    NG

    CHECK HARNESS AND CONNECTOR (COWL SIDE JUNCTION BLOCK LH - BATTERY AND BODY GROUND) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (COWL SIDE JUNCTION BLOCK LH - BATTERY AND BODY GROUND)


    1. A01FQ0YE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Cowl Side Junction Block LH)

      Disconnect the cowl side junction block LH connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      5E-1 - Body ground Always 11 to 14 V
      5A-35 - Body ground Power switch on (IG) 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      5B-1 - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK COWL SIDE JUNCTION BLOCK LH


    1. A01FV6CE01
      Text in Illustration
      *a

      Component without harness connected

      (Cowl Side Junction Block LH)

      Remove the cowl side junction block LH Click here.

    2. Reconnect the 5A, 5B and 5E cowl side junction block LH connectors.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A-32 (IG) - Body ground Power switch on (IG) 11 to 14 V

    NG

    REPLACE COWL SIDE JUNCTION BLOCK LH Click here

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here