THEFT DETERRENT SYSTEM Intrusion Sensor Cancel Switch Circuit

DESCRIPTION


WIRING DIAGRAM

A01FUXIE06

INSPECTION PROCEDURE

Note


  • If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. READ VALUE USING GTS (INTRUSION SENS OFF SW)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. According to the display on the GTS, read the Data List.

      Main Body (Main Body ECU [Multiplex Network Body ECU])
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Intrusion Sens OFF SW Intrusion sensor cancel switch/ON or OFF

      ON: Intrusion sensor cancel switch on

      OFF: Intrusion sensor cancel switch off

      		 -
      OK
      The indicator on the GTS switches between ON and OFF in accordance with the intrusion sensor cancel switch status.

    NG

    CHECK HARNESS AND CONNECTOR (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] - MAP LIGHT ASSEMBLY AND BODY GROUND) Click here

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] - MAP LIGHT ASSEMBLY AND BODY GROUND)


    1. Disconnect the N13 main body ECU (multiplex network body ECU) connector.

    2. Disconnect the Y9 map light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      N13-11 (SSW1) - Y9-13 (SOFF) Always Below 1 Ω
      Y9-10 (GND) - Boy ground Always Below 1 Ω
      N13-11 (SSW1) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR CANCEL SWITCH)


    1. A01FVTBE08

      Remove the map light assembly (intrusion sensor cancel switch) Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      13 (SOFF) - 10 (GND) Intrusion sensor cancel switch not pressed 10 kΩ or higher
      13 (SOFF) - 10 (GND) Intrusion sensor cancel switch pressed Below 1 Ω

    NG

    REPLACE MAP LIGHT ASSEMBLY (INTRUSION SENSOR CANCEL SWITCH) Click here

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here