NETWORK GATEWAY ECU REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note


    • When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    A01FQQME01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel RH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel RH.

    3. w/ Airbag Cut Off Switch:


      1. Disconnect the connector.

  4. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE INSTRUMENT SIDE PANEL RH

    A01FQQME01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel RH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel RH.

    3. w/ Airbag Cut Off Switch:


      1. Disconnect the connector.

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    A01FS1UE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel finish panel end RH.

    2. Detach the 5 clips and 2 guides and remove the instrument panel finish panel end RH.

  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FSJSE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01FT2W

    1. Detach the 5 clips and 2 guides.

    2. Disconnect the connectors, detach the clamp and remove the No. 2 instrument panel under cover sub-assembly.

  9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01FVEAE01
    Text in Illustration
    *1 Screw <A>
    *2 Bolt <E>

    1. Remove the 3 screws <A> and 2 bolts <E>.

    2. Detach the 6 clips.

    3. Disconnect the connectors, detach the clamp and remove the glove compartment door assembly.

  10. REMOVE NETWORK GATEWAY ECU


    1. A01FVL0

      Remove the 2 screws and network gateway ECU.