INTEGRATION RELAY REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01FUJM

      Remove the 4 clips and engine room side cover.

  6. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FTUX

      Remove the 7 clips and cool air intake duct seal.

  7. REMOVE NO. 1 RELAY BLOCK COVER


    1. A01FU3T

      Detach the claw closer to the front of the vehicle and pull the No. 1 relay block cover in the direction shown by the arrow in the illustration to remove it.

  8. REMOVE NO. 2 INTEGRATION RELAY


    1. A01FSS0

      Disconnect the 3 connectors from the No. 2 connector holder.

    2. A01FU6U

      Detach the clamp, 3 claws and remove the No. 2 connector holder.

    3. A01FSXL

      Detach the 2 claws and pull out the No. 2 integration relay.

    4. A01FUN2

      Disconnect the 3 connectors and remove the No. 2 integration relay.

      Note


      • Do not drop or allow any impact on parts.

      • Do not touch the connector.