NIGHT VIEW MAIN SWITCH REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter Click here.

      CAUTION:

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off.

  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FSJSE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    A01FTVNE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument panel finish panel end LH.

    2. Detach the 5 clips and 2 guides and remove the instrument panel finish panel end LH.

  4. REMOVE INSTRUMENT SIDE PANEL LH

    A01FUFWE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the instrument side panel LH.

    2. Using a moulding remover, detach the 7 clips and remove the instrument side panel LH.

  5. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    A01FTZQE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the No. 1 instrument panel garnish sub-assembly.

    2. Using a moulding remover, detach the 4 clips and remove the No. 1 instrument panel garnish sub-assembly.

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01FVMJ

    1. Remove the 3 screws <A>.

    2. Detach the 2 claws.

    3. Disconnect the connectors, detach the clamp and remove the No. 1 instrument panel under cover sub-assembly.

  7. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    A01FSAJ

    1. Detach the 9 clips and guide.

    2. Disconnect the connectors and remove the No. 1 instrument panel safety pad sub-assembly.

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    A01FQEH

    1. Detach the 9 clips and 2 guides and remove the instrument cluster finish panel assembly.

  9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. Detach the 6 clips and 6 claws.

    2. Disconnect the connectors and remove the instrument cluster finish panel sub-assembly.

      A01FSZR
  10. REMOVE SATELLITE SWITCH SET

    A01FV02

    1. Detach the 2 claws and remove the satellite switch set.