ULTRASONIC SENSOR (for Front Side) REMOVAL


  1. REMOVE FRONT BUMPER COVER


    1. for Sport Package:

      Click here

    2. except Sport Package:

      Click here

  2. REMOVE NO. 1 ULTRASONIC SENSOR


    1. A01FS2J

      Disconnect the 4 ultrasonic sensor connectors and fog light connector.

      Tech Tips

      The illustration shows the No. 1 ultrasonic sensor for the RH corner. The horizontal orientation of the No. 1 ultrasonic sensor for the LH corner and front sensor LH and RH is opposite that of the image shown in the illustration.

    2. A01FRLI

      Detach the 2 claws and remove the No. 1 ultrasonic sensor.

      Tech Tips


      • The illustration shows the No. 1 ultrasonic sensor for the RH corner. The horizontal orientation of the No. 1 ultrasonic sensor for the LH corner and front sensor LH and RH is opposite that of the image shown in the illustration.

      • Use the same procedure for all No. 1 ultrasonic sensors.

    3. A01FRQ9

      for Corner Sensor LH Side:

      Detach the clamp and remove the No. 1 ultrasonic sensor.

  3. REMOVE NO. 4 ENGINE ROOM WIRE


    1. for Sport Package:

      A01FQOUE01

      Detach the 9 clamps and remove the No. 4 engine room wire.

    2. except Sport Package:

      Detach the 10 clamps and remove the No. 4 engine room wire.

      Text in Illustration
      *A for Sport Package *B except Sport Package

  4. REMOVE ULTRASONIC SENSOR CLIP (for Corner Sensor)


    1. A01FQVHE01
      Text in Illustration
      *1 Protective Tape

      for LH Side:

      Using a screwdriver, detach the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.

  5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    1. A01FTZ0

      Detach 4 the claws and remove the No. 1 ultrasonic sensor retainer from the front bumper cover.

      Tech Tips


      • The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner and front sensor LH and RH is opposite that of the image shown in the illustration.

      • Use the same procedure for all No. 1 ultrasonic sensor retainers.