ULTRASONIC SENSOR (for Rear Side) INSTALLATION


  1. INSTALL ULTRASONIC SENSOR CLIP


    1. A01FS06

      Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.

      Tech Tips


      • The illustration shows the No. 1 ultrasonic sensor assembly for the LH corner and back sensor LH and RH. The position of the No. 1 ultrasonic sensor clip for the RH corner is on the opposite side.

      • Use the same procedure for all No. 1 ultrasonic sensor clips.

  2. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • If a No. 1 ultrasonic sensor retainer has been removed, replace it with a new one. Install the No. 1 ultrasonic sensor with a new No. 1 ultrasonic sensor retainer as a set to the rear bumper assembly.

    • Use the same procedure for all No. 1 ultrasonic sensor retainers.


    1. A01FUZA

      Attach the 2 claws and install 2 No. 1 ultrasonic sensor retainers to the No. 1 ultrasonic sensor.

    2. Clean the rear bumper cover surface.


      1. Remove the double-sided tape from the rear bumper cover.

      2. Wipe off any tape adhesive residue with cleaner.

    3. A01FSCFE01
      Text in Illustration
      *a Primer

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

    4. Peel off the release paper from the 2 No. 1 ultrasonic sensor retainers.

    5. A01FSXFE01
      Text in Illustration
      *a Protrusion of the mark

      Align the No. 1 ultrasonic sensor retainer with No. 1 ultrasonic sensor with the mark on the rear bumper cover and install it as shown in the illustration.

      Note

      The double sided tape of a No. 1 ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the No. 1 ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark and connect it.

      • Press on the areas indicated by the arrows in the illustration with a force of 30 N (3.0 kgf) for 3 seconds and install the No. 1 ultrasonic sensor retainer firmly so that there is no clearance between the No. 1 ultrasonic sensor retainer and rear bumper cover.

  3. INSTALL NO. 3 LUGGAGE ROOM WIRE


    1. Attach the 4 clamps to install the No. 3 luggage room wire.

    2. Connect the 4 connectors.

  4. INSTALL REAR BUMPER COVER

    Click here