BLIND SPOT MONITOR SYSTEM FREEZE FRAME DATA


  1. FREEZE FRAME DATA


    1. Whenever a DTC is detected, the blind spot monitor sensor stores the current vehicle (sensor) state as Freeze Frame Data.

  2. CHECK FREEZE FRAME DATA


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the blind spot monitor main switch (integration control and panel assembly) on.

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.

    6. According to the display on the GTS, select the trouble code data display with Freeze Frame Data.

      Blind Spot Monitor Master
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Warning Indicator Turning on (Master) State of the outer rear view mirror indicator RH turning on / OFF or ON

      OFF: The following conditions are not met


      • ON: All of the following conditions are met


        • Not during initial check

        • Vehicle detected in right hand side warning area

        • Right turn signal: off

        • Vehicle speed 40 km/h (25 mph) or more

        • Shift lever in any position except R

        • Blind spot monitor warning light not illuminated

      		 -
      Warning Indicator Flashing (Master) State of the outer rear view mirror indicator RH flashing / OFF or ON

      OFF: The following conditions are not met


      • ON: All of the following conditions are met


        • Not during initial check


        • Vehicle detected in right hand side warning area


        • Right turn signal: on


        • Vehicle speed 40 km/h (25 mph) or more


        • Shift lever in any position except R


        • Blind spot monitor warning light not illuminated

      		 -
      Turn Switch State Master side, slave side state of the turn SW / master ON, slave ON or OFF

      Master ON: Right turn switch on

      Slave ON: Left turn switch on

      OFF: Switch not operated

      		 -
      Master Side Turn Signal State of the master side turn signal / OFF or ON

      ON: Right turn signal received

      OFF: Right turn signal not received

      		 -
      Reverse State of the shift position R signal / OFF or ON

      ON: Shift lever in R

      OFF: Shift lever in any position except R

      		 -
      Vehicle Speed Vehicle speed signal / Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Vehicle stopped: 0 km/h (0 mph) -
      Steering Angle Steering angle sensor / Min.: -3072°, Max.: 3070.5°

      Left turn: Increases

      Right turn: Decreases

      		 -
      VGRS Relative Angle Compensation value of steering angle calculated by VGRS / Min.: -8.192 rad, Max.: 8.191 rad

      Left turn: Increases

      Right turn: Decreases

      		 Only vehicles with VGRS
      Power Supply Voltage Power supply voltage / Min.: 0 V, Max.: 50 V Always: 11 to 14 V -

  3. CLEAR FREEZE FRAME DATA

    Note

    Clearing the DTCs will also clear the Freeze Frame Data.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the blind spot monitor main switch (integration control and panel assembly) on.

    4. Turn the GTS on.

    5. Clear the DTCs and Freeze Frame Data.