BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB4

DTC Code DTC Name
C1AB4 Open in Outer Mirror Indicator(Master)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects an open in the outer rear view mirror indicator RH.

DTC Code DTC Detection Condition Trouble Area
C1AB4

Both of the following conditions are met:


  • Blind spot monitor main switch (integration control and panel assembly) is on.

  • The current flowing to the indicator is below a specified value when indicator operation voltage is being sent to the indicator.

  • Harness or connector

  • Outer mirror RH

  • Outer mirror actuator assembly RH

  • Front multiplex network door ECU RH

  • Blind spot monitor sensor RH

WIRING DIAGRAM

A01FSX9E03

INSPECTION PROCEDURE

Note

When checking for DTCs, make sure that the blind spot monitor main switch (integration control and panel assembly) is on.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    NG

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - FRONT MULTIPLEX NETWORK DOOR ECU RH) Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - FRONT MULTIPLEX NETWORK DOOR ECU RH)


    1. Disconnect connector T39 from the blind spot monitor sensor RH.

    2. Disconnect connector Q4 from the front multiplex network door ECU RH.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T39-6 (OMIR) - Q4-21 (BSMI) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT OUTER MIRROR RH (OUTER REAR VIEW MIRROR INDICATOR RH)


    1. Remove the outer mirror RH Click here.

    2. Inspect the outer mirror RH (outer rear view mirror indicator RH) Click here.


    NG

    REPLACE OUTER MIRROR RH Click here

    OK

  4. REPLACE OUTER MIRROR ACTUATOR ASSEMBLY RH


    1. Replace the outer mirror actuator assembly RH Click here.


    NEXT

  5. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    NG

    REPLACE FRONT MULTIPLEX NETWORK DOOR ECU RH Click here

    OK

    END (OUTER MIRROR ACTUATOR ASSEMBLY RH IS DEFECTIVE)

  6. REPLACE FRONT MULTIPLEX NETWORK DOOR ECU RH


    1. Replace the front multiplex network door ECU RH Click here.


    NEXT

  7. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      No DTCs are output.

    NG

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here

    OK

    END (FRONT MULTIPLEX NETWORK DOOR ECU RH IS DEFECTIVE)