PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the multi-media module receiver assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC Code DTC Detection Condition Trouble Area
C1626 A fail flag is transmitted from the steering angle sensor.

  • Spiral with sensor cable sub-assembly

  • Multi-media module receiver assembly

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the accessory meter assembly (for 12.3 Inch) or multi-display (for 8 Inch) after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Replace the spiral with sensor cable sub-assembly Click here.


    NEXT

  2. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1626 is output A
      No DTC is output B

    B

    END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE)

    A

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here