HARD DISK DRIVE INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL HARD DISC


    1. A01FU9P

      Push the hard disc in the direction of the arrow shown in the illustration to install it.

    2. A01FVMC

      Install the cover in the direction of the arrow shown in the illustration.

    3. Install the 2 screws.

  2. INSTALL NO. 2 RADIO BRACKET


    1. A01FTW7E02

      Install the No. 2 radio bracket with the 3 screws.

    2. Install the ion generator bracket with the screw labeled A.

  3. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. Connect the connectors.

    2. A01FTJJ

      Insert the multi-media module receiver assembly with bracket.

      Note

      When inserting the multi-media module receiver, do not press the knobs on it.

    3. Attach the 2 claws and 2 clips.

    4. Install the multi-media module receiver assembly with bracket with the 2 screws.

  4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL


    1. Connect the connector.

    2. Attach the 9 clips and guide to install the center instrument cluster finish panel.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH


    1. Install the luggage compartment trim cover LH.

  7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


    1. Install the luggage compartment floor mat.