HARD DISK DRIVE REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FSJSE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  6. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. A01FVOP

      Remove the 2 screws.

    2. A01FS6G

      Detach the 2 claws and 2 clips.

    3. Pull out the multi-media module receiver assembly with bracket.

    4. Disconnect the connectors and remove the multi-media module receiver assembly with bracket.

  7. REMOVE NO. 2 RADIO BRACKET


    1. A01FTW7E02

      Remove the screw labeled A and ion generator bracket.

    2. Remove the 3 screws and No. 2 radio bracket.

  8. REMOVE HARD DISC


    1. A01FTN9

      Remove the 2 screws.

    2. A01FRUR

      Move the cover in the direction of the arrow shown in the illustration to remove it.

    3. A01FTBG

      Remove the hard disc in the direction of the arrow shown in the illustration.