FRONT DOOR SPEAKER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01FRRP

      Detach the 3 claws and remove the front door inside handle bezel plug.

  6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    1. A01FTIQ

      Detach the 2 clips and 5 claws.

    2. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.

  7. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01FTYO

      Using a moulding remover A, detach the claw and remove the courtesy light assembly.

    2. Disconnect the connector.

  8. REMOVE FRONT DOOR HOLE COVER


    1. Remove the front door hole cover.

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01FRGD

      Remove the 3 screws.

    2. Detach the 9 clips.

    3. A01FT5UE01

      Detach the reference boss in the direction indicated by the arrow in the illustration.

    4. Using a screwdriver, detach the 4 claws and remove the front door trim board.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Reference Boss
      *2 Protective Tape

    5. Disconnect each connector.

    6. A01FSKV

      Disconnect the front door lock remote control cable and front door inside locking cable.

  10. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. Disconnect the connector.

      A01FTLTE01
      Text in Illustration
      *A w/o Mark Levinson Speaker System *B w/ Mark Levinson Speaker System

    2. Remove the 4 screws.

    3. Detach the claw and remove the front No. 1 speaker assembly.

      Note

      Do not touch the cone of the speaker.