AUDIO AND VISUAL SYSTEM Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the multi-media module receiver assembly via this circuit.

WIRING DIAGRAM

A01FU3WE09

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the N69 multi-media module receiver assembly connector.

    2. Disconnect the N168 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      N69-6 (VV+) - N168-8 (VV+) Always Below 1 Ω
      N69-14 (VV-) - N168-9 (VV-) Always Below 1 Ω
      N69-6 (VV+) - Body ground Always 10 kΩ or higher
      N69-14 (VV-) - Body ground Always 10 kΩ or higher
      N69-13 (SG) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here