REAR SEAT INNER BELT ASSEMBLY INSPECTION


  1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    1. A01FU5LE07
      Text in Illustration
      *a

      Component without harness connected

      (Rear Seat Inner with Center Belt Assembly LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (+) - 3 (LBR-) Tongue plate is installed Below 1 Ω
      2 (+) - 3 (LBR-) Tongue plate is not installed 1 MΩ or higher

      If the result is not as specified, replace the rear seat inner with center belt assembly LH.

    2. A01FS9SE01
      Text in Illustration
      *a 45°

      Check the degree of tilt when the ELR begins to lock.


      1. Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the belt.

        Note

        Do not disassemble the retractor.

  2. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH


    1. A01FU5LE05
      Text in Illustration
      *a

      Component without harness connected

      (Rear Seat Inner with Center Belt Assembly RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (+) - 3 (RBR-) Tongue plate is installed Below 1 Ω
      2 (+) - 3 (RBR-) Tongue plate is not installed 1 MΩ or higher

      If the result is not as specified, replace the rear seat inner with center belt assembly RH.