SEAT POSITION SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the drivers seat of RHD and LHD vehicle.

  • The procedures listed below are for the front passenger side of an LHD vehicle.


  1. INSTALL SEAT POSITION SENSOR


    1. Fully insert the pin of the seat position airbag sensor into the seat frame, and then temporarily install the seat position airbag sensor with the "TORX" screw.

    2. A01FT5CE01
      Text in Illustration
      *a Surface of the Lower Rail
      *b 32.3 to 32.5 mm (1.272 to 1.279 in.)

      Adjust the distance from the seat position airbag sensor to the bottom surface of the lower rail to 32.3 to 32.5 mm (1.272 to 1.279 in.) as shown in the illustration.

    3. Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note


      • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.

      • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

      • Make sure that the distance from the seat position airbag sensor to the bottom surface of the lower rail is 32.3 to 32.5 mm (1.272 to 1.279 in.).

    4. Connect the connector.

    5. Check that there is no looseness in the installation parts of the seat position airbag sensor.

  2. INSTALL UPPER SEAT TRACK RAIL COVER LH


    1. Attach the clip to install the upper seat track rail cover LH.

    2. Install the screw.

  3. INSTALL FRONT SEAT ASSEMBLY LH

    for Sports Seat Type: Click here

    for Luxury Seat Type: Click here

    for Standard Seat Type: Click here