PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A0A

DTC Code DTC Name
C1A0A Front Radar Sensor Region Code Mismatch

DESCRIPTION

The driving support ECU uses the millimeter wave radar sensor to detect obstacles in front of the vehicle. Based on this information, the driving support ECU sends pre-crash safety control operation signals.

When the millimeter wave radar sensor is replaced with a new one, it acquires the country specification information from the driving support ECU. Also, when the driving support ECU is replaced with a new one, it receives country specification information from the main body ECU. When country specification information in the sensor, ECU and/or main body ECU do not match, DTC C1A0A is stored.

DTC Code DTC Detection Condition Trouble Area
C1A0A While the initial check is running, the power switch is on (IG) and the pre-crash safety system is operating, the country specification information in the driving support ECU and the millimeter wave radar sensor do not match for 2 seconds or more.

  • Millimeter wave radar sensor assembly

  • Driving support ECU

INSPECTION PROCEDURE

Note

When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed Click here.

PROCEDURE


  1. READ VALUE USING GTS (COUNTRY)


    1. Use the Data List to check if the country specification information is correct Click here.

      Radar Cruise
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Country# (F Radar Sens) Millimeter wave radar sensor country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC, NOFIX Actual country code -
      Result
      Result Proceed to
      Country specification information for vehicle and millimeter wave radar sensor match A
      Country specification information for vehicle and millimeter wave radar sensor do not match B

      Tech Tips

      The country specification information stored in the driving support ECU is determined by the country specification information stored in the main body ECU. If the country specification information for the millimeter wave radar sensor matches the vehicle, the country specification information for the main body ECU and driving support ECU is incorrect and the main body ECU and driving support ECU need to be replaced.


    B

    REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY Click here

    A

  2. CHECK FOR DTC (PRE-CRASH SAFETY SYSTEM)


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1A0A is not output.

      Note

      When replacing the driving support ECU, always replace it with a new one and be sure to perform initialization Click here. If an ECU which was installed to another vehicle is used, the information stored in the ECU will not match the information from the vehicle, and as a result, a DTC may be stored.


    NG

    REPLACE DRIVING SUPPORT ECU Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here