INJECTOR DRIVER REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01FUJM

      Remove the 4 clips and engine room side cover.

  6. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FTUX

      Remove the 7 clips and cool air intake duct seal.

  7. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FTF3E01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FVNL Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover may be damaged.

  8. REMOVE NO. 1 AIR CLEANER INLET


    1. A01FPYO

      Remove the bolt and No. 1 air cleaner inlet.

  9. REMOVE NO. 1 ENGINE COVER


    1. A01FTWO

      Remove the 3 clips and No. 1 engine cover.

  10. REMOVE INJECTOR DRIVER


    1. A01FVOVE02
      Text in Illustration
      *1 Lock Lever
      *a Release
      *b Lock with Connector

      Move the lock levers in the direction indicated by the arrow to release the 3 connector locks. Disconnect the 4 connectors from the injector driver.

    2. A01FU7TE01
      Text in Illustration
      *1 Bolt
      *2 Nut

      Remove the bolt, 2 nuts and injector driver.

      Note

      Be careful not to drop or strike the injector driver.