IGNITION COIL AND SPARK PLUG REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FUJM

      Remove the 4 clips and engine room side cover.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FTUX

      Remove the 7 clips and cool air intake duct seal.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01FTF3E01

      Place both hands on the sides of the cover as shown in the illustration, lift the cover to detach the 2 clips near the front in the order shown in the illustration, and then lift the cover further to detach the rear clip and remove the cover.

      Text in Illustration
      A01FVNL Areas to place hands when lifting cover

      Note

      If the cover is lifted rearward or forward and to the right or left at the same time, the cover may be damaged.

  4. DISCONNECT NO. 2 VENTILATION HOSE


    1. A01FRYF

      Disconnect the No. 2 ventilation hose from the cylinder head cover.

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01FQ6J

      Disconnect the mass air flow meter connector.

    2. Disconnect the clamp from the air cleaner.

    3. A01FS2N

      Disconnect the VSV hose.

    4. A01FRIA

      Disconnect the 4 clamps.

    5. Remove the hose clamp and air cleaner cap with air cleaner hose.

  6. REMOVE IGNITION COIL ASSEMBLY


    1. A01FSKM

      for RHD:

      Detach the 2 wire harness clamps from the inverter bracket.

    2. A01FUAI

      for RHD:

      Remove the 2 bolts and inverter bracket from the inverter.

    3. A01FSET

      Remove the 2 bolts and disconnect the inverter reservoir tank assembly.

    4. A01FTWIE01

      for Bank 1:


      1. Remove the 3 nuts and disconnect the clamp labeled A using a clip remover. Then, disconnect the clamp labeled B using needle-nose pliers.

        Note

        Do not damage the claws of the clamp.

      2. Disconnect the manifold absolute pressure sensor connector, VVT sensor connector and 3 ignition coil connectors to disconnect the engine wire.

      3. Remove the 3 bolts and 3 ignition coils.

    5. A01FRRQ

      for Bank 2:


      1. Remove the 2 nuts and disconnect the clamp.

      2. Disconnect the VVT sensor connector and 3 ignition coil connectors to disconnect the engine wire.

      3. Remove the 3 bolts and 3 ignition coils.

  7. REMOVE SPARK PLUG


    1. Remove the 6 spark plugs.